Valve Inlet Rubber for S30 & Pin Valves

The Valve Inlet Rubber is a replacement inlet seal for S30 and pin valves on home brew pressure barrels. Fit one when the old inlet seal is worn, perished or no longer holding gas, and the valve will seal properly again.

Key points

• Replacement inlet seal
• For S30 valves
• For pin valves
• A cheap way to bring a leaking valve back into use

When to replace it

If your barrel loses pressure, or gas hisses from the valve when you inject CO2, a tired seal is a common cause. Check the inlet rubber, the relief rubber and the o-ring together, as they are all inexpensive to swap at the same time.

Other valve spares

• Valve Relief Rubber - the relief seal for S30 and pin valves
• Valve O Ring - replacement o-ring for S30 and pin valves
• Valve Sealing Washer - the flat washer between valve and cap
• S30 Valve or Pin Valve - if the whole valve needs replacing

For home brewers who want to keep an existing pressure barrel valve working rather than replace the whole valve. If you are unsure which valve you have, check it before you buy.